How to fix a blocked blade motor on Husqvarna Lawn and Garden Equipment?
If the blade motor of your Husqvarna Lawn and Garden Equipment is blocked, it's likely due to grass or another object wrapped around the blade disc. Check the blade disc and remove any obstructions. Also, if the blade disc is sitting in a pool of water, move the robotic lawnmower and try to prevent water from collecting in that area.
Why does my Husqvarna Lawn and Garden Equipment have a low battery?
If your Husqvarna Lawn and Garden Equipment is showing a low battery, several factors could be at play. First, ensure that the charging station and guide wire are installed correctly. If the guide wire is broken or disconnected, find and fix the break. If the battery is old, consider contacting your local dealer to test or replace it. Finally, check the charging station's indicator lamp for a red flashing light, which could indicate a defective charging station antenna.
What to do if Husqvarna Lawn and Garden Equipment goes outside working area?
If your Husqvarna Lawn and Garden Equipment is operating outside the designated working area, it could be due to several reasons. First, ensure that the boundary wire connections to the charging station are not crossed and are connected correctly. Also, verify that the boundary wire isn't too close to the edge of the working area and is laid according to the instructions. If there are disturbances from metal objects or buried cables nearby, try moving the boundary wire. If the mower is struggling to differentiate the signal from a nearby installation, place it in the charging station and generate a new loop signal.
Why is my Husqvarna Lawn Mower showing a red flashing light?
If the Husqvarna Lawn Mower is displaying a red flashing light, it means there's an interruption in the charging station's antenna. Contact your local Husqvarna representative for assistance.
What to do if my Husqvarna AUTOMOWER 450X displays a solid red light?
If your Husqvarna Lawn Mower shows a solid red light, this indicates a fault within the charging station's circuit board or an incorrect power supply. In this case, you should contact your local Husqvarna representative for assistance.
Why is the Husqvarna AUTOMOWER 450X Lawn Mower showing a blue flashing light?
If the Husqvarna Lawn Mower displays a blue flashing light, it typically indicates a problem with the boundary loop connection or a break in the loop. First, ensure the boundary wire connectors are correctly attached to the charging station. If the problem persists, there may be a break in the boundary loop. Locate the break, replace the damaged wire section with a new one, and securely splice it using an original coupler.
Why is the light flashing blue on my Husqvarna Lawn Mower?
A blue flashing light indicates that the boundary loop is not connected to the charging station. Ensure that the boundary wire connectors are properly fitted to the charging station.
How to find breaks in the loop wire of a Husqvarna AUTOMOWER 450X?
If the loop wire of your Husqvarna Lawn Mower is broken, it's often due to unintentional physical damage, like accidentally cutting it while gardening, or stretching the wire too much during installation. To find the break, try halving the loop's distance where you suspect the damage. Keep halving the distance until you're left with a very short section of wire. This should help you pinpoint the location of the break.
What to do if the Husqvarna Lawn Mower has a blue flashing light?
If your Husqvarna Lawn Mower is showing a blue flashing light, it could be due to a couple of reasons. First, the boundary loop might not be properly connected to the charging station. Make sure the boundary wire connectors are correctly fitted. Alternatively, there might be a break in the boundary loop. If so, locate the break, replace the damaged section with a new loop wire, and splice it using an original coupler.
How to fix a break in the boundary loop of my Husqvarna AUTOMOWER 450X?
To fix a break in the boundary loop, find where the break is located. Replace the damaged section of the loop with a new loop wire, and splice it using an original coupler.
General| Cutting Width | 24 cm |
|---|---|
| Cutting Height Min | 20 mm |
| Cutting Height Max | 60 mm |
| Battery Type | Li-Ion |
| Typical Mowing Time on One Charge | 270 min |
| Sound Level Measured | 58 dB(A) |
| Area Capacity | 5000 m² |
| Maximum Incline Within the Working Area | 45 % |
| Cutting System | 3 pivoting razor blades |
| GPS-assisted navigation | Yes |
| Lift sensor | Yes |
| Tilt sensor | Yes |
| Ultrasonic sensor | Yes |
| Battery Voltage | 18 V |
| Weight | 13.9 kg |
| Weather Resistance | Yes |
| Smart Connectivity | Yes |
To Next Page
