6. Use the arrow buttons to set the date format
and then push the BACK button.
3.12.12.2 To set the language
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Language.
3. Use the arrow buttons to select language
and then push the BACK button.
3.12.12.3 To set the Country & Timezone
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Country & Timezone.
3. Use the arrow buttons to select country and
then push the BACK button.
3.12.12.4 To set the unit format
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Unit format.
3. Use the arrow buttons to select unit format
and then push the BACK button.
3.12.12.5 To reset all user settings
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Settings >
General > Reset all user settings
.
3. Use the right arrow button to select
Proceed
with reset of all user settings?
4. Push the OK button to reset all the user
settings.
Note:
Security level, PIN code, Loop signal,
Messages, Date & Time, Language
and
Country
settings
are not reset.
3.12.12.6 The About menu
The
About
menu displays information about the
product, for example serial number and firmware
versions.
3.12.13 Accessories
Settings for accessories mounted on
the product can be made in this menu.
3.12.13.1 Information
This menu handles accessories mounted on the
product. Contact your local Husqvarna
representative for more information on available
accessories.
3.12.13.2 Automower
®
Connect
Automower
®
Connect is included in Automower
®
430XH/450XH.
To pair Automower
®
Connect and the product
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower
®
Connect >
Pairing > New pairing
.
3. Follow the instructions in the app.
To enable the GeoFence function
GeoFence is a GPS-based theft protection that
makes a virtual fence for the product. You will get
a message if the product is moved on the other
side of the GeoFence.
1. Put the product in the center of the work
area.
2. Do steps 1–3 in
To get access to the menu
on page 26
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
GeoFence > Activate GeoFence
.
4. Push the OK button.
5. Select
Activate GeoFence
and push the OK
button.
To set a new center point for the Geofence
function
1. Put the product in the center of the work
area.
2. Do steps 1–3 in
To get access to the menu
on page 26
.
3. Use the arrow buttons and the OK button to
move through the menu structure
1230 - 002 - 30.03.2020
Installation - 35
To Next Page
Loading...
