Accessories > Automower Connect >
GeoFence > New center point
.
4. Push the OK button.
To set the GeoFence level of sensitivity
The higher level of GeoFence sensitivity, the
easier the alarm starts.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
GeoFence
.
3. Use the arrow buttons to select level of
GeoFence sensitivity.
4. Push the BACK button.
To use the SMS function
The SMS function sends you an SMS when the
product is moved out of the GeoFence.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
Communication > Use SMS
.
3. Push the OK button.
4. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Automower Connect >
Communication > SMS phone numbers
.
5. Push the number buttons to enter the
telephone number with country code. For
example (+)46701234567.
6. Push the BACK button.
Note:
There is a maximum of 10 SMS each
month from the product.
Network
APN settings
The product must specify APN settings to be able
to use and send data via the mobile net. Settings
for Husqvarna SIM is default.
3.12.13.3 Ultrasonic Automower
®
450XH
The
Ultrasonic
function makes the product
decrease speed when the product comes near an
obstacle. The product operates at a lower speed
if the
Ultrasonic
function is disabled.
To set the Ultrasonic function
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Ultrasonic > Use
.
3.12.13.4 Headlights
To set the schedule for the headlights
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Headlights > Schedule
.
3. Select between
Always ON, Evening only,
Evening & night
or
Always OFF
.
Note:
Evening only
will start the schedule for the
headlights at sunset and stop at midnight.
Evening & night
will start the schedule for the
headlights at sunset and stop at sunrise.
To set the Flashes when fault function
The headlights flashes if the product stops to
operate because of a fault if
Flashes when fault
is
enabled.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Headlights > Flashes when
fault
.
3. Use the OK button to enable or disable the
Flashes when fault
function.
3.12.13.5 To avoid collisions with the mower
house
The wear on the product and the mower house
decreases when you select
Avoid collisions with
mower
.
1. Do steps 1–3 in
To get access to the menu
on page 26
.
2. Use the arrow buttons and the OK button to
move through the menu structure
Accessories > Mower house > Avoid
collisions with mower
.
36
- Installation
1230 - 002 - 30.03.2020
To Next Page
Loading...
