Husqvarna CEORA - Table of Contents

Contents
1 Safety
1.1 Safety definitions
...................................................3
1.2 General safety instructions....................................3
1.3 Safety instructions for installation..........................4
1.4 Safety instructions for operation............................4
1.5 Safety instructions for maintenance...................... 4
1.6 Battery safety........................................................ 4
1.7 To lift and move the product..................................5
2 Introduction
2.1 Support..................................................................6
2.2 Product description............................................... 6
2.3 System description................................................6
2.4 System overview................................................... 7
2.5 Product overview drive unit, CEORA
™
544/546 EPOS............................................................ 8
2.6 Product overview cutting deck, CEORA
™
RZ 43L/43M................................................................ 8
2.7 Product overview charging station,
CEORA
™
CS4............................................................ 9
2.8 Control panel overview........................................10
2.9 LED indicator on the product...............................10
2.10 Symbols on the product.................................... 11
2.11 Symbols on the battery..................................... 11
2.12 Symbols in the app............................................11
2.13 General manual instructions............................. 12
3 Installation
3.1 Introduction - Installation..................................... 13
3.2 Primary components for installation.................... 13
3.3 To prepare for installation................................... 13
3.4 To examine where to put the reference station...13
3.5 To examine where to put the charging station.... 13
3.6 To examine where to install the objects on
the map..................................................................... 15
3.7 Installation of the product.................................... 17
4 Settings
4.1 Schedule............................................................. 24
4.2 Cutting height...................................................... 24
4.3 Pattern.................................................................24
4.4 Operation............................................................ 24
4.5 Accessories.........................................................25
4.6 General (Bluetooth
®
only)................................... 25
4.7 Security (Bluetooth
®
only)...................................25
4.8 Automower
®
Connect (Bluetooth
®
only)............. 26
4.9 Messages............................................................26
4.10 Download firmware over the air (Firmware
over the air FOTA)....................................................
26
5 Operation
5.1 To set the product to ON.....................................27
5.2 To start the product............................................. 27
5.3 To select operation mode....................................27
5.4 appDrive .............................................................27
5.5 Work area selection............................................ 27
5.6 Operation mode Park.......................................... 27
5.7 Operation mode Park at Maintenance point........28
5.8 To stop the product............................................. 28
5.9 To set the product to OFF................................... 28
5.10 To charge the battery........................................ 28
5.11 To release the wheel brakes and move
the product................................................................ 28
6 Maintenance
6.1 Introduction - maintenance..................................30
6.2 Maintenance schedule........................................ 30
6.3 To put the cutting deck in service position.......... 32
6.4 To put the cutting deck in cut position.................32
6.5 Clean the product................................................33
6.6 Replacement of the blades and blade discs....... 33
6.7 Adjustment of the wheel brushes........................ 35
6.8 Battery.................................................................35
7 Troubleshooting
7.1 Introduction - troubleshooting..............................36
7.2 Fault messages...................................................36
7.3 Information and warning messages.................... 43
7.4 LED indicator lamps on the charging station.......43
7.5 Symptoms........................................................... 44
8 Transportation, storage and disposal
8.1 Safety instructions for transportation...................46
8.2 To put the product into storage........................... 46
8.3 Transportation of batteries.................................. 46
8.4 Disposal.............................................................. 46
9 Technical data
9.1 Technical data.....................................................49
9.2 Registered trademarks........................................52
10 Applicable to US/CA market
10.1 Supplier's Declaration of Conformity................. 53
10.2 Compliance requirements................................. 53
2 1691 - 006 - 09.01.2023