8
ASSEMBLY
TO DRIVE TRAC TOR OFF SKID (See Op-
er a tion section, for location and func tion of
con trols)
WARNING: Before start ing, read, un der stand and follow
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
• Be sure all the above assembly steps have been com-
pleted.
• Check engine oil level and fi ll fuel tank with gasoline.
• Place freewheel control in "transmission engaged"
po si tion.
• Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
• Place motion control lever in neutral (N) position.
• Press lift lever plunger and raise attachment lift lever to
its highest position.
• Start the engine. After engine has started, move throttle
control to idle position.
• Release parking brake.
• Slowly move the mo tion control lever for ward and slowly
drive tractor off skid.
• Apply brake to stop trac tor, set parking brake and place
motion con trol lever in neutral po si tion.
• Turn ignition key to "OFF" position.
Continue with the in struc tions that follow.
FIG. 4A
FIG. 4B
TO INSTALL BAGGER COM PO NENTS TO
TRAC TOR (See Figs. 4A-4D)
• Remove discharge chute from rear of tractor. Unhook
the two (2) straps and pull chute out and away from
tractor.
• Remove the two (2) 3/8 nuts and fl at washers from the
bolts at the tractor back plate.
• Using the nuts and fl at washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
• Install the two upper support brack ets through the
back plate and to the chas sis, using the 10 x 19 mm
(3/8"x3/4") carriage bolts and locknuts sup plied. Tight en
se cure ly.
• Assemble both support brackets to the outside of the
baggger support tube using two each 3/8 x 63,5mm
hex bolts13/32" I.D. fl at washers and 3/8 locknuts from
parts bag. Tight en securely.
• Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
DISCHARGE
CHUTE
3/8 NUT
FLATWASHER
SUP PORT
TUBE
FLAT
WASHER
3/8 NUT
BOLT
FIG. 4C
3/8 LOCK NUT
3/8 LOCK NUT
SUPPORT BRACKET
13/32 FLAT
WASHER
3/8 HEX BOLT
3/8 CAR RIAGE BOLT
FIG. 4D
HOOK
BACKPLATE
SLOT
DIS CHARGE
CHUTE
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to fl oat with the
mower deck when moving on uneven terrain.
To Next Page
Loading...
