What to do if the Husqvarna Floor Machine engine starts but stops due to high carbon monoxide?
If the display shows the warning "HIGH CARBON MONOXIDE CONCENTRATION", the carbon monoxide values are higher than permitted levels. Ensure that the work area has good airflow. The engine cannot start until the carbon monoxide values are below permitted levels.
Why won't my Husqvarna DURATIQ XP6 Floor Machine engine start?
The battery is not charged. Charge the battery. Another possible cause is that the emergency stop button is engaged. Turn the emergency stop button on the control panel clockwise to disengage it. The propane tank could be empty, so fill or replace the propane tank. Also, the propane tank valve could be closed, so turn the propane tank valve to open the propane tank. Examine the fuse on the engine; if the fuse is damaged, replace it.
What does "WATER LEVEL LOW" mean on my Husqvarna DURATIQ XP6?
The water is low in the water tank. Fill water in the water tank and check the level sensor.
Why does my Husqvarna Floor Machine grinder stop?
The grinding speed is too low. Increase the grinding speed and/or adjust weights. Also, the fuel pressure may be too low, so replace the propane tank.
What does "MOTOR OVERLOAD" mean on my Husqvarna Floor Machine?
The engine overloads, and the display gauge shows more than 90%. Decrease the engine load, referring to the display gauge for engine current. The engine may also overload if the gauge shows near 100%. Let the product cool down.
What does "HIGH OIL TEMPERATURE" mean on a Husqvarna DURATIQ XP6?
The engine is too hot. Stop the engine and check the oil cooling fins. If necessary, clean the oil cooling fins.
Why does my Husqvarna DURATIQ XP6 Floor Machine engine start then stop?
The engine starts but stops after 1-2 minutes because the air filter is clogged or dirty. Replace the air filter. If the problem continues, speak to an approved service agent.
What does "CONTROL VOLTAGE LOW" mean on my Husqvarna Floor Machine?
Low control voltage. Do a check of the battery voltage.
What does "SERVICE" mean on my Husqvarna Floor Machine?
A servicing of the product is necessary. Speak to your servicing dealer.
What to do if the Husqvarna Floor Machine engine is on but the grinder doesn't start?
The engine is on, but the grinder does not start because the belt is broken. If the belt is broken, let a service center replace it. Turn one of the grinding discs by hand. If all grinding discs rotate together, the belt is not damaged. If one grinding disc rotates freely, then the belt is broken.
General| Brand | Husqvarna |
|---|---|
| Model | DURATIQ XP6 |
| Category | Floor Machine |
| Language | English |
To Next Page