Husqvarna BB 700 - User Manual

Questions and Answers

J
Jonathan CastroAug 11, 2025
Why my Husqvarna Floor Machine does not start?
- C
  calvincarlsonAug 11, 2025
  If your Husqvarna Floor Machine doesn't start, several factors could be at play. First, ensure the machine is properly connected to a functioning power outlet. Check the extension cable for any disconnections or damage, replacing it if necessary. An electrician should verify the correct voltage at the terminals and inspect the power supply. If only one phase is coming into the product, disconnect the power supply, wait 5 minutes, then reconnect and start the product. Also, voltage relays should be checked to make sure they are correctly configured. If these steps don't resolve the issue, it could be due to a defective component.
A
Andrew MendozaAug 17, 2025
How to reduce vibration in my Husqvarna BB 700 Floor Machine?
- P
  petermillerAug 17, 2025
  Excessive vibration or unusual noises in your Husqvarna Floor Machine can stem from several issues. Start by examining the burnishing disc for any signs of wear, damage, or excessive movement. Also, the coupling could be worn and need replacement. A defective bearing on the axle drive shaft can also cause these symptoms, so inspect the bearing and replace it if necessary.
J
Jeffery LoweAug 22, 2025
What to do if my Husqvarna Floor Machine has decreased burnishing performance?
- S
  Steven ChapmanAug 23, 2025
  If your Husqvarna Floor Machine's burnishing performance has decreased or is non-existent, the burnishing pad may be worn and needs replacing. Also, ensure that you are using the correct type of burnishing pad for the surface you are working on; if not, replace it with the appropriate pad.
H
Heather NashAug 28, 2025
Why does my Husqvarna BB 700 Floor Machine stop after a while?
- S
  sherry56Aug 28, 2025
  If your Husqvarna Floor Machine stops after running for a while, it could be due to the motor protection switch being activated by an overload. Try decreasing the load. Also, the motor itself might have a defect, so you should check the motor.
J
Jeffrey PattersonSep 3, 2025
How to restore control voltage to my Husqvarna BB 700 Floor Machine?
- C
  Courtney DavilaSep 3, 2025
  If there's no control voltage in your Husqvarna Floor Machine, first check the emergency stop button to ensure it's not engaged. Turn the emergency stop button clockwise to disengage. If the relay for the emergency stop button has 3 green LEDs, the circuit is closed. Reset the circuit breakers when they are off. Also, verify that the operator presence control is not engaged by installing the key for the operator presence control.