Husqvarna BMG 555 P - User Manual

Questions and Answers

C
Cynthia BarberAug 14, 2025
How to start Husqvarna BMG 555 P Floor Machine if the engine won't start?
- V
  Victoria GuerreroAug 15, 2025
  If your Husqvarna Floor Machine engine won't start, several factors could be at play. First, ensure the emergency stop button on the control panel isn't engaged; turn it clockwise to disengage. Next, check the propane tank—it might be empty, in which case you should fill or replace it. Also, verify that the propane tank valve is open. Examine the fuse on the engine and replace it if damaged. Lastly, the battery may not be charged, so ensure it is fully charged.
R
Rose MartinAug 18, 2025
What to do if Husqvarna BMG 555 P engine starts then stops?
- E
  edward22Aug 18, 2025
  If the engine of your Husqvarna Floor Machine starts but stops shortly after, the propane tank is likely almost empty. Refill or replace the propane tank to resolve this issue.
D
David ParksAug 21, 2025
Why Husqvarna BMG 555 P Floor Machine product is not easy to hold on to?
- S
  seth25Aug 21, 2025
  If your Husqvarna Floor Machine is difficult to hold on to, it could be due to several reasons. You may need to increase the number of diamond tools installed to reduce the load on both the product and the operator. Also, a broken belt can cause this issue; if one grinding disc rotates freely when you turn the others by hand, the belt is broken and needs replacing. Adjusting the engine speed or the forward speed of the product across the floor may also help.
O
Oscar KennedyAug 25, 2025
What to do if Husqvarna BMG 555 P Floor Machine engine stops?
- A
  Alyssa KentAug 26, 2025
  If the engine of your Husqvarna Floor Machine stops, the most likely cause is an empty propane tank. Refill or replace the propane tank to get the machine running again.
C
Carol BakerAug 27, 2025
What to do if Husqvarna BMG 555 P engine is on but the grinder does not start?
- A
  Anthony RodriguezAug 27, 2025
  If the engine of your Husqvarna Floor Machine is running but the grinder isn't starting, a potential cause is a broken belt. To check this, turn one of the grinding discs by hand. If only that disc rotates freely, the belt is broken and needs to be replaced.
A
April CookAug 31, 2025
Why Husqvarna BMG 555 P Floor Machine sounds as if it decreases the speed too much?
- K
  Kathleen FletcherAug 31, 2025
  If your Husqvarna Floor Machine sounds like it's decreasing in speed too much, the pressure in the propane tank might be too low. Try filling or replacing the propane tank. Also, pushing down the handlebar slightly to lift the grinding head from the surface when you start the product may help.
A
Alexandra DixonSep 3, 2025
What to do if Husqvarna BMG 555 P smells of smoke?
- A
  Amber ChristensenSep 3, 2025
  If your Husqvarna Floor Machine smells of smoke, make sure that the engine speed is not between 1200 and 2600 rpm.
C
Courtney BlanchardSep 6, 2025
Why Husqvarna BMG 555 P Floor Machine makes an irregular scratch pattern?
- R
  rodrigueztinaSep 6, 2025
  If your Husqvarna Floor Machine is creating an irregular scratch pattern, ensure all diamond tools are installed correctly and are at the same height on the grinding discs. Also, verify that all diamond segments have the same diamond grit and bond; if rough segments are present, space them out equally and operate the product on an abrasive surface until all segments have the same height. Similarly, for resin tools, confirm they have the same diamond grit and bond and are free from contamination; clean them by operating them briefly on a lightly abrasive surface. Finally, check the grinding discs for broken sections or excessive movement.
J
Jenny PachecoSep 10, 2025
Why are there sudden unwanted movements in my Husqvarna BMG 555 P Floor Machine?
- A
  Adriana PopeSep 10, 2025
  Sudden, unwanted movements in your Husqvarna Floor Machine can be caused by damaged grinding discs. Inspect the grinding discs for damaged parts and excessive movement. Also, ensure that all diamond tools are correctly attached and at the same height.