Maintenance schedule
Maintenance Daily Monthly
Clean the external surfaces of the product with water. Refer to
To clean the product on
page 23
.
X
Do a general inspection. Refer to
To do a general inspection on page 24
. X
Do a check of the drive belt. If it is necessary, adjust the tension of the drive belt. Refer to
To adjust the tension of the drive belt on page 24
X
Do a check of the machine stop button. Refer to
To do a check of the machine stop button
on page 10
.
X
Do a check of the ON button and OFF button. Refer to
To do a check of the ON button
and OFF button on page 9
.
X
Do a check of the ground fault circuit interrupter. Refer to
To do a check of the ground
fault circuit interrupter on page 11
.
X
Do a check of the water flow. If the water flow is not sufficient, do a check of the water
filter. If it is necessary, clean the water filter. Refer to
To clean the water filter on page
23
.
X
Do a check of the blade guards. Refer to
To do a check of the blade guard on page 11
. X
Do a check of the cutting blade. Refer to
Cutting blades on page 12
. X
Lubricate the bushings and the lever for cutting depth adjustment. Refer to
To lubricate
the product on page 24
.
X
Lubricate the nut at the drive belt plate and the axle. Refer to
To lubricate the product on
page 24
.
X
To clean the product
WARNING: Use protective glasses.
When you clean the product, dirt and
harmful material can eject from the product.
CAUTION: A blocked air intake
decreases the performance of the product
and can cause the motor to become too hot.
• Let the product become cool before you clean it.
• Do not clean electrical components with water.
• Use a weak cleaning agent. Put on protective gloves
to prevent skin irritation.
• Always clean all the equipment at the end of the
work day. Do not use a high-pressure washer to
clean the product.
• Remove blockage from all air openings.
To clean the water filter
CAUTION: A blocked water filter
decreases the water flow to the cutting blade
and can cause the cutting blade to become
too hot.
1620 - 003 - 28.02.2022 23
To Next Page
Loading...
