English – 23
6.10 Throttle lock, throttle trigger and
return spring – refi tting
1
Lubricate all pins and mating surfaces with a light
oil.
2
Fit the throttle cable (A), throttle control (B) and
spring (C). (see fi gure 22)
3
Hold the spring and insert the throttle lock into the
cut-out in the handle. (see fi gure 23)
4
Check that the throttle cable casing is in the right
position in the petrol tank. Press in the casing until
it stops. (see fi gure 24)
5
Fit the throttle control pin (E) with the help of a
punch. (see fi gure 23)
6
Fit the throttle lock (D) by pressing it onto the shaft
in the handle. (see fi gure 25)
Safety equipment
A
D
C
B
E
D
7
Now loosen the spring.
Cleaning and inspection
• Clean and inspect all parts carefully. If there are
any cracks or other defects replace the dama-
ged parts with new ones. Always use original
parts.
• Check that the spring is not broken and has not
lost its tension.
7
Assemble the handle insert using a screw, when
the throttle control, lever, throttle cable and throttle
control lock with pin are fi tted correctly. (see fi gure
25)
Fig 21
Fig 22
Fig 23
Fig 24
Fig 25
To Next Page
Loading...
