28 – English
Repair instructions
7.7 Ignition module/fl ywheel – removal
1
Remove the cylinder cover. Disconnect the HT lead,
remove the spark plug and fi t piston stop 502 54 15-
01. in its place. Take off the starter assembly, release
the leads from the cable guide and remove it. (see
fi gure 8)
4
Knock on the punch using a metal mallet until
the fl ywheel releases from the shaft. Remove the
punch and the fl ywheel. (see fi gure 10)
Cleaning and inspection
• Clean all parts, especially the tapers on the
fl ywheel and shaft.
• Check that the fl ywheel is not cracked or da-
maged in any other way.
2
If replacing the ignition module (B), loosen the
cable lug (C) and screw (A) and unscrew it. The
ignition module can be left in place if you are simply
removing the fl ywheel. (see fi gure
9)
3
Loosen the fl ywheel nut (E) using a suitable socket
and remove it.(see fi gure 10)
When replacing the cables, they are fi tted on the
stop switch. as shown in fi gure. (see fi gure 9)
A
C
D
A
B
Fig 9
Fig 8
Fig 10
E
To Next Page
Loading...
