6.5 Blade
6.5.1 To remove and replace the blade
1. Lock the blade with a block of wood.
2. Remove the blade bolt.
3. Remove the blade.
4. Examine the blade support and blade bolt to see if
there are damages.
5. Examine the motor shaft to make sure that it is not
bent.
6. When you attach the new blade, point the angled
ends of the blade in the direction of the cutting
cover.
7. Make sure that the blade is aligned with the center
of the motor shaft.
8. Lock the blade with a block of wood. Attach the
spring washer and tighten the bolt and washer with a
torque.
9. Pull the blade around by hand and make sure that it
turns freely.
WARNING: Use heavy duty gloves. The
blade is very sharp and cuts can easily
occur.
10. Start the product to do a test of the blade. If the
blade is not correctly attached, there is vibration in
the product or the cutting result is unsatisfactory.
6.6 Wheels
6.6.1 To remove and attach the rear wheels
1. Put the product on its side. Make sure that it is
stable.
2. Remove the nut cap, the nut, and the wheel on the 2
sides of the product.
3. If it is necessary, remove the 2 ball bearings from
the wheel and the gear.
20 - Repair instructions 1292 - 001 -
To Next Page
Loading...
