26 – English
Maintenance
Check the battery
The machine is equipped with a maintenance-free battery.
The battery has a service window showing different colours.
• White = Charge battery
• Green = OK.
• Red = Change battery.
Clean the battery and holder with soap/water solution.
A discarded or replacement battery should be handled as
hazardous waste.
The Cutting Unit Components
The components mentioned are:
1 Cotter pin
2 Link joint
3 Cutting unit bracket
4 Clipping height adjusters
5 Universal drive shaft with quick connectors
6 Attachment point for service position
7 Service strut
8 Belt cover
9 Gear
Fitting the cutting head
1 Place the machine on a flat surface and apply the parking
brake.
2 Start the engine and lower the lift arms to floating mode.
3 Turn off the motor.
4 Fit the universal drive shaft to the cutting unit. Slide the
ring sideways to release the quick coupling and the
universal drive shaft can be pushed onto the shaft pin.
5 Make sure the rubber casing is folded over the front
universal joint.
6 Remove the bolts and pins from the link joint on the lift
arms.
7 Slide in the cutting unit so that the link joint aligns with the
opening in the unit.
8 Insert the bolts for the link joints and the pins on both
sides.
!
WARNING! Lead-acid batteries produce
explosive gases. Avoid sparks, open flames
and smoking close to batteries. Always wear
protective glasses in the vicinity of batteries.
4
1
5
3
2
6
7
4
8
9
!
WARNING! If the help function is engaged,
the lift arms will move with great force if
someone releases the lifting lever. Observe
caution to avoid trapping your hand.
Risk of crush injuries.
To Next Page
Loading...
