English – 13
ASSEMBLING AND ADJUSTMENTS
8 Insert the bolts for the link joints and the pins on both
sides.
9 Remove the service hatch.
10 Fit the rear universal drive shaft.
11 Fit the locking chain to the universal joint cover around the
lifting beam.
12 Refit the service cover.
13 Start the engine and lift the cutting unit halfway up.
14 Turn off the motor.
15 Fit the lifting eyes which are attached to the lift arms. Pull
out the catch and press in the lifting eye. There is one for
each lift arm.
16 Check and adjust the tilt angle of the cutting unit. For more
information, see 'Cutting Height and Tilt Angle
Adjustment'.
To Next Page
Loading...
