English
–
9
MA
CHINE´S SAFETY EQ
UIPMENT
General
Ignition ke
y
The ignition k
ey is used to turn the engine on and off together
with all electrical functions except the power outlet.
1 OFF - the machine is powered down
2 ON - Glow plug heating and drive position
3 START - spring-back ignition position
The ignition key is on the right side of the dash.
Ignition ke
y check
•
Check the ignition key by starting and stopping the
engine. See instructions under the heading Starting and
stopping.
• The engine should start when the ignition key is turned to
START (3).
• The engine should stop immediately when the ignition key
is turned to OFF (1).
Saf
ety circuit
The machine has a saf
ety circuit that triggers whenever the
driver gets off the seat while the blades are engaged. The
safety circuit is also tripped when the parking brake has not
been applied and the driver rises from the seat.
Drive to the blades is stopped when the safety circuit is
tripped. There is a short delay to prevent stopping if the driver
bounces on the seat.
• When the safety circuit has stopped the drive to the
cutting unit, the control must be pushed and pulled out
again to start the blades. Drive to the blades can be
started only when the driver is sitting on the seat.
• Push in the lever to disengage the blades.
• Pull out the lever to engage the drive of the blades.
Saf
ety circuit check
•
Check daily to ensure that the safety system works by
attempting to start the engine when one of the conditions
above is not met. Change the conditions and try again.
Speed limiter
The speed of the machine is steplessly regulated with tw
o
pedals. Pedal (1) is used to drive forwards, and pedal (2) to
drive backwards.
The machine is braked when the forward pedal is released.
The reverse pedal can also be used if additional braking
power is required.
!
WARNING! Never use a machine that has
faulty safety equipment!
If your machine fails any checks contact
your service agent to get it repaired.
2
1
To Next Page
Loading...
