Husqvarna P520 D - Accessories; Pivot Wheel Bearings; Universal Drive Shaft Joints; Cutting Unit Bracket

40 – English
Lubrication
Accessories
Lubrication or other maintenance of optional equipment or
accessories is not described in this manual. This equipment
too, naturally, requires maintenance. See the manuals for the
respective accessories for instructions.
Pivot wheel bearings
4 nipples (sprocket and pivot shaft bearing), lubricate with
grease gun until grease appears.
Universal drive shaft joints
• Remove the service hatch.
• Loosen the two quick connectors on the universal drive
shaft and remove the universal drive shaft.
• The universal drive shaft has two grease nipples, one on
the front hub and one on the rear hub. Lubricate with a
grease gun until the grease is forced out.
• Lubricate the telescopic joint of the universal drive shaft
with grease.
Cutting unit bracket
• Lubricate swivel joints and shafts with oil.
Lift arm rear bearings
• Remove the service hatch. For more information, see
'Removing the ride-on mower covers'.
• 2 grease nipples, one on each side. Lubricate with a
grease gun until the grease is forced out.
Lift cylinder
• Remove the service hatch.
• 2 grease nipples, one on each side. Lubricate with a
grease gun until the grease is forced out.
The drive shaft front support bearing
• Lubricate with a grease gun until the grease is forced out.
The drive shaft rear support bearing
• 2 grease nipples. Lubricate with a grease gun until the
grease is forced out.