English – 25
MAINTENANCE AND SERVICE
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.
!
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
The engine is switched off.
The parking brake is applied.
The ignition key is removed.
The cutting unit is disengaged.
Maintenance Daily maintenance Maintenance interval in hours
Before starting
After work is
completed
10 40 100 200 400 800
Check the safety system X
Check for fuel and oil leakage. O
Check the engine’s oil level X X
Check coolant level and antifreeze. X X
Checking the transmission oil level X X
Check and clean the engine’s cooling air intake, clean
the radiator.
X X
Cleaning X
Start engine and blades, listen for noise O
Check nuts and screws O
Clean underside of cutting unit X
Lubricate throttle cable X
Grease the blade shafts X
Check air filter X
Check the tyre pressures. X
Lubricate according to lubrication schedule, see under
heading "LUBRICATION"
X X
Clean thoroughly around engine X
Clean thoroughly around transmission X
Clean the air filter and empty the particle collector X
Checking the blades X
Replace the fuel filter. X
To Next Page
Loading...
