26 – English
MAINTENANCE AND SERVICE
1)
First change after 25 hours. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.
2)
Maintenance and replacement are required more often in dusty conditions.
3)
First change after 25 hours.
4)
Conducted by
authorised service workshop.
X = Described in this operator's manual
O = Not described in this operator's manual
Maintenance Daily maintenance Maintenance interval in hours
Before starting
After work is
completed
10 40 100 200 400 800
Change engine oil and filter
1)
X
1)
Check the synchronisation between the front and rear
wheels.
O
Change hydraulic oil and hydraulic filter
3, 4)
. O
3, 4)
Check belt tension and condition (alternator belt, PTO
belt, cutting unit belt)
X
Check the battery condition, clean as necessary. X
Clean transmission air intake X X
Check oil level in the bevel gear, top up if necessary. X
Check the wheel nuts. O
Check the parking brake X
Replace the air filter
2)
. X
2)
Change belts (PTO belt and cutting unit belt). X
Change the oil in the bevel gear. X
Change pump and alternator belt X
Change coolant (50% glycol). X
Service at an authorised service representative. O
IMPORTANT! When the machine is in operation the hoses are under high pressure. Do not try to connect or disconnect the hoses
when the hydraulic system is operational. This can result in serious personal injuries.
To Next Page
Loading...
