102
Maintenance
5. Remove the pins on both sides.
6. Tilt the cutting unit.
7. Secure the cutting unit with the pin in the service
handle. Keep track of the hairpin spring.
8. The cutting unit in the service position.
Releasing the Service Position
Images, see “Placing in the service position”.
1. Remove the pin from the service handle and lower
the cutting unit.
2. Install the pins on both sides.
3. Lower the cutting unit to the mowing position.
When the engine has stopped, the ignition switch
must be in the ON position and the lever in the
lowered position within 3 seconds, otherwise turn
the ignition switch again.
4. Fit the propeller shaft and close the service hatch.
Fit the cover screw.
The propeller shaft only fits one way.
Right-hand side pin
Securing in the service position
To Next Page
Loading...
