105
Maintenance
Replacing the power take-off belts
Always replace the belts in pairs.
1. Remove the driver's seat.
2. Remove the protective cover above the hydraulic
pump's drive shaft.
3. Remove the ignition keys from the machine.
4. Release (1) the drive shaft from the hydraulic
pump and remove the spacer ring (2) from the
coupling.
WARNING:
If the blades are cracked, whether caused by poor
repair or other damage, they could break while being
used. Cracked and defective blades must always be
replaced. The risk increases if the blades are poorly
balanced.
1
2
Drive shaft spacer ring
To Next Page
Loading...
