108
Maintenance
4. Slacken off two screws and remove the three
others for the gear housing. Turn the gear housing
so that the belts can be moved under the pulley.
5. Check that the belt tensioning equipment is not
jammed or binding and replace the spring.
6. Position the new belt and reinstall the gear
housing.
7. Attach the new belt.
The belt position decal is on the cutting unit under
the protective cover.
8. Install the protective covers.
9. Attach the cutting unit to the machine. See “Side
shifting the cutting unit” on page 96.
Gearbox turned
To Next Page
Loading...
