6. Hold the battery connector in position and install the
2 screws.
7. Hold the motor in position and install the 3 screws.
8. Install the cable cover.
CAUTION: Make sure that the battery
connector cables are in the correct position.
9. Install the user interface. Refer to
To remove and
install the user interface on page 16
.
10. Assemble the power trigger. Refer to
To assemble
the power trigger on page 12
.
11. Assemble the crankcase. Refer to
To disassemble
and assemble the crankcase on page 10
.
CAUTION: Make sure that all cables and
parts are installed correctly before you
assemble the crankcase.
12. Install the worm gear. Refer to
To remove and install
the worm gear on page 8
.
13. Install the brake drum. Refer to
To remove and
install the brake drum on page 8
.
14. Install the drive sprocket. Refer to
To remove and
install the drive sprocket on page 8
.
15. Install the drive sprocket cover. Refer to
To remove
and install the drive sprocket cover on page 8
.
5.8 User interface
5.8.1 To remove and install the user interface
1. Disassemble the crankcase. Refer to
To
disassemble and assemble the crankcase on page
10
.
2. Disassemble the power trigger and the power trigger
lockout. Refer to
To disassemble the power trigger
on page 11
.
3. Disconnect the chain brake sensor.
16 - Repair instructions 1204 - 001 - 03.12.2019
To Next Page
Loading...
