Name: Husqvarna TC 238T
Brand: Husqvarna
Rating: 5 (1 reviews)

To Next Page

To Previous Page

3. Remove the bolt (A).

4. Put the full lever shroud (B) in the slots (C).

5. Push the lever (D) through the full lever shroud

and install the bolt (A).

6. If it is necessary to adjust the full lever, do the

steps that follow.

a) If the grass is heavy or wet, remove the bolt

and put the full lever in the fully retracted

position. Install the bolt again.

b) If the grass is light or dry, remove the bolt

and put the full lever in the fully extended

position. Install the bolt again.

To install the presence lever for the

grass catcher

1. Stop the engine and engage the parking brake.

2. Put the presence lever (A) into the slots in the

backplate.

3. Install the screw (B) and the nut (C).

To adjust the seat

1. Sit in the seat.

2. Lift up the seat adjustment lever (A).

3. Move the seat until it is in a position where you

can push the brake and clutch pedals down.

4. Release the seat adjustment lever (A) to lock the

seat in position.

To connect the battery

WARNING: Risk of electrical shock.

Make sure that ignition switch is in the

OFF position and that the ignition key is

removed.

The cable connections are on the plate on the right

side of the product, above the rear wheel.

1. Make sure that the red cable (A) is tightly

installed to the starter solenoid.

2. Make sure that the protective sleeve (B) does not

touch the terminal end (C) on the black cable (D).

2010 - 003 - 10.04.2023

Other manuals for Husqvarna TC 238T

Questions and Answers:

Need help?

Do you have a question about the Husqvarna TC 238T and is the answer not in the manual?

General