Husqvarna TX 300 User Manual (English)

Questions and Answers:

S
stephenschristopherSep 7, 2025
What to do if my Husqvarna Motorcycle engine turns but does not start?
- C
  Christopher SmithSep 7, 2025
  If your Husqvarna Motorcycle engine turns but doesn't start, consider these potential causes and solutions. First, ensure you are following the correct start procedure. If the motorcycle has been out of use for a while, old fuel in the float chamber might be the issue, so empty it. Check for any interruptions in the fuel feed, such as a blocked fuel tank breather or fuel tap. Also, a spark plug that's oily or wet should be cleaned, dried, or replaced. Make sure the spark plug electrode distance (plug gap) is correctly adjusted. Inspect the ignition system for any faults and check the kill switch for frayed cables or defects. Clean and treat any loose or oxidized connectors or ignition coils with contact spray. Finally, check for water in the carburetor or blocked jets.
D
Daniel GarnerSep 8, 2025
Why won't my Husqvarna Motorcycle engine crank with the electric starter (TX 300)?
- B
  bradley98Sep 8, 2025
  If your Husqvarna TX 300 Motorcycle engine won't crank with the electric starter, there are several possible reasons. It could be due to an operating error during the start procedure. The battery might be discharged, requiring you to recharge it and check the charging voltage, closed current, and alternator. A blown main fuse could also be the cause, so replace it. Additionally, the starter relay or starter motor might be faulty, and each should be checked.
C
Carrie RiveraSep 10, 2025
What to do if my Husqvarna Motorcycle engine has too little power?
- K
  Kathleen JacksonSep 10, 2025
  If your Husqvarna Motorcycle engine has too little power, the issue could stem from a few sources. Check for an interrupted fuel feed by inspecting the fuel tank breather and cleaning the fuel tap. A very dirty air filter can also cause this, so clean the air filter and air filter box. Examine the exhaust system for leaks or deformation and consider changing the glass fiber yarn filling in the main silencer. Also, a fault in the ignition system could be the reason, or a damaged diaphragm or reed valve housing.
D
Devin WilliamsSep 12, 2025
What to do if my Husqvarna Motorcycle engine stalls or pops into the carburetor?
- R
  Robert RogersSep 12, 2025
  If your Husqvarna Motorcycle engine stalls or pops into the carburetor, it might be due to a lack of fuel, so ensure the fuel tap is in the ON or RES position and refuel if necessary. Another cause could be the engine taking in bad air, so check the intake flange and carburetor for tightness. Lastly, a loose or oxidized connector or ignition coil can cause this issue, so clean the connector and treat it with contact spray.
K
kathleen91Sep 13, 2025
How to fix a Husqvarna Motorcycle engine that does not speed up?

Husqvarna TX 300 Specifications

General

Displacement	293.2 cc
Bore x Stroke	72 mm x 72 mm
Starter	Electric starter
Transmission	6-speed
Cooling	Liquid cooled
Rear Suspension	WP XACT Monoshock with linkage
Front Brake	Disc brake
Rear Brake	Disc brake
Ground Clearance	370 mm
Seat Height	950 mm
Engine Type	2-stroke, single cylinder
Fuel Tank Capacity	8.5 l
Front Suspension	WP XPLOR-USD, Ø 48 mm