Page 28 2828e 28
ANTI-SWEAT HEATERS
The anti-sweat heaters are located along the lower glass perimeter and inside the nose discharge panel.
Servicing the anti-sweat heaters requires removal of the corner caps, then the glass or nose discharge
panel. To remove corner caps simply hold part and pull upwards. Corner caps naturally fit tight to
prevent undesirable removal. To remove glass, just pull upwards. The nosing panel is a snap fit,
therefore a tool might be required to assist removal.
Remove nosing by lifting upwards near the exterior of the refrigerator, then slide part toward interior of
refrigerator. Caution should be taken at all times to prevent personal injury or damage to parts.
To Next Page