Page 4
SECTION 2
INSTALLATION
SHIPPING DAMAGE
All equipment should be thoroughly examined for shipping damage before and during
unloading.
This equipment has been carefully inspected at our factory and the carrier has assumed
responsibility for safe arrival. If damaged, either apparent or concealed, a claim must be made
to the carrier.
If there is any damage, the carrier should be notified immediately and an inspection requested.
The delivery receipt must be noted that equipment was received damaged. If damage is of a
concealed nature, we suggest the carrier be contacted immediately, or no later than (3) days
following delivery. The claim must be filed with the carrier, by the consignee, for all damage.
SHIPPING BRACES
Move the fixture as close as possible to its permanent location, then remove all packaging and
shipping braces. Remove all separately packed accessories such as kits, shelves, etc.
EXTERIOR LOADING
These cases are not structurally designed to support excessive external loading, loading such as
the weight of a person. Therefore, do not walk on the top of these refrigerators or damage to the
refrigerator as serious personal injury could occur.
LOCATION
These refrigerators, like other open refrigerators, are sensitive to air disturbances. Air currents
passing around them will seriously impair their operation. Do not allow air-conditioning,
electric fans, open doors or windows, etc. to create air currents around these cases.
Located in the lower front and rear of the base are vented panels. These panels allow air
circulation to the condensing unit. Blocking or restricting air circulation through these panels
can cause poor performance and damage the refrigeration system.
INSTALL THE REFRIGERATOR NO CLOSER THAN (4) FOUR INCHES FROM A
WALL OR OTHER STORE FIXTURES.
To Next Page
Loading...
