To Next Page

To Previous Page

REV B 8-2 117364

5. Service more often under dusty or dirty conditions. Use caution when servicing to prevent dust contamination in the engine. Do not clean filter element. Replace

with a new one.

6. Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Check spring tension adjustment. Otherwise, replace belt every

400 hours or 2 years whichever comes first. Check and adjust the spring tension after 50 hours of use as outlined in the Hydraulic Pump Belt Adjustment

section of the Super 104 General Service Manual (p/n 117364).

7. Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon canister, and

grommets. Replace as needed.

8. More often under dusty or dirty conditions and during hot weather.

9. Inspect ROPS after the first 20 hours of operation and then after every 500 hours of operation or yearly whichever comes first.

REFERENCES:

A. Refer to engine owner’s manual for engine service information.

NOTE: After completing maintenance cycle (500 hours), repeat cycle.