2.4
OPERATION OVERVIEW
The PLC is a programmable logic controller which allows the operator to run the machine in both manual and automatic
modes.
In manual mode, all functions can be operated by using a combination of selector switches on the control console and the
PLC function buttons. Also the operator has the ability to execute a single cut utilizing a pre-programmed
ONE CUT MODE”.
In automatic mode, the PLC has the capacity to program and store 99 jobs. Designated job numbers can be programmed
for quantity required (maximum of 999 pieces). Piece lengths from 0.1” to 500” (12700 mm) and cut angles from
90
0
through to 45
0
left or right. Jobs can be run individually or in a QUEUE which allows a maximum of 5 jobs to run con-
secutively.
NOTE: If an emergency situation arises during any operation, use the large red mushroom “emergency stop” button
located on the control panel to shut down the machine.
CONTROL SYSTEM, MITSUBISHI PLC 500
To Next Page
Loading...
Need help?
General
