HydraMaster Titan 575 User Manual (English)

Other manuals for HydraMaster Titan 575

Owner’S Guide And Maintenance Schedule57 pages

Questions and Answers:

M
Michele BrownAug 27, 2025
What to do if my HydraMaster Titan 575 Vacuum Cleaner has water in the exhaust?
- S
  Samuel MillerAug 27, 2025
  If you notice water in the exhaust of your HydraMaster Vacuum Cleaner, it could be due to a few reasons. The recovery tank might be overfilled with water or foam, so inspect and drain the tank if needed. Condensation in the system, especially in cool, humid weather, can also cause this, but it should dissipate after a few minutes of running. A leaking heat exchanger could also be the culprit, so inspect and repair or replace it as necessary.
T
Terry FoxAug 27, 2025
What to do if my HydraMaster Titan 575 Vacuum Cleaner engine turns over but will not start?
- J
  jkruegerAug 27, 2025
  If your HydraMaster Vacuum Cleaner engine turns over but doesn't start, first, check if the recovery tank is full and drain it if necessary. Inspect the recovery tank float for any faults. Check if fuel is reaching the carburetor by testing the fuel pump for power and inspecting the pump itself. If the engine is flooded, remove and dry the spark plug. Inspect the spark plugs for wear or dirt and replace if needed. If none of these steps work, consult a qualified service technician.
J
Joanne WilliamsAug 25, 2025
What to do if my HydraMaster Titan 575 Vacuum Cleaner is unable to achieve normal cleaning solution temperature?
- D
  davidabbottAug 26, 2025
  If your HydraMaster Vacuum Cleaner isn't reaching the normal cleaning solution temperature, check the temperature control knob to ensure it's properly adjusted. Inspect the thermovalve for any faults. Also, excessive solution flow at the tool can be a cause, so inspect the cleaning tool jet for size and wear. Hard water scale buildup in the heat exchanger can also affect temperature, so descale the system. Check for blockages on the inlet side of the heat exchanger, and ensure the heat selector valve is in the "HOT" position.
R
randallbobbyAug 25, 2025
What to do if my HydraMaster Vacuum Cleaner engine will not turn over?
- A
  Allison McneilAug 25, 2025
  If your HydraMaster Vacuum Cleaner engine isn't turning over, start by checking the battery terminals for looseness or corrosion; clean and tighten them if needed. The battery might be dead, so try recharging or replacing it, and test the charging system. Also, check the main fuse. If these steps don't work, the vacuum blower might be seized (attempt to turn the coupler by hand), the ignition switch could be faulty (test for power), the starter solenoid might be faulty (test for power in the "START" position), or the starter motor could be faulty (test for power in the "START" position). If none of these steps resolve the issue, consult a qualified service technician.