13
Jets 1 control
Your spa is equipped with a two speed motor on pump 1. Depress the JETS1 pad to
turn on pump 1(low speed), depress the JETS1 pad second time to turn on pump
1(high), and depress the JETS1 pad again to turn pump1 off. Corresponding spa jets
will operate when pump 1 is on (low or high). Anytime Pump1 has been manually
turned on, it will automatically turn off after approximately 15 minutes on high speed
and 4 hours for low speed. LED light JETS1 is on when the pump 1 is on.
Aux. control (if spa equipped with 2 speed pump or a single speed pump)
If your spa is equipped with a two speed pump, depress the AUX pad to
turn pump to (low speed) - if a single speed pump, depress AUX pad once to turn
pump on, depress the AUX pad a second time to turn 2 speed pump to (high) depress
AUX pad once to turn single speed pump off. Depress the AUX pad again to turn 2
speed pump off. Corresponding spa jets will operate when pump 2 is on (low or high).
Anytime Pump 2 has been manually turned on, it will automatically turn off after
approximately 15 minutes. LED light AUX is on when the pump 2 is on.
Blower control (if equipped with Air blower)
If your spa is equipped with an Air Blower depress the BLOWER pad to turn on the
Blower. Depress the BLOWER pad a second time to turn the Blower off.
Corresponding air jets will operate when the Blower is on. Anytime the Blower has
been manually turned on, it will automatically turn off after approximately 15 minutes.
Mood Light control
If your spa equipped with a Mood Light, depress the LIGHT pad to turn on the Light.
Depress the LIGHT pad a second time to turn the Light off. The spa mood is light
preprogrammed with assortment of lighting effects. When you turn the Light off, and
turn on within 5 seconds it advances to the next effect. When you turn the Light off for
more than 5 seconds, it remembers that last effect you selected. The next time you
turn on the Light, it will display the sameeffect. The Light will automatically turn off after
approximately 4 hours.
For Standard Light application every time you depress the LIGHT pad the Light will turn
on and off.
Spa Mode selection
Depressing the MODE pad will allow you to select either "Standard" or "Economy"
mode. In Standard mode the water temperature is held to the set temperature at all
times. After the set temperature is reached, the heater turns off and the 24 hour circu
lation pump and ozone generator continue to operate to oxidize and sanitize the spa
water. In Economy mode the 24 hour circulation pump and ozone generator continues
to operate and the heater will turn on only during a programmed filter cycles. See the
circulation pump for details.
Circulation Pump
Your system is equipped with a 24-hour circulation pump which provides 24 hours
countinous water circulation and filtration. The spa’s entire contents is completely fil
tered 50-80 times each day. It works like this: a dedicated, energy efficient, quite
circulation pump constantly draws water from the spa, runs it through the filters and the
heater (heating only when necesssary), then back through return jets to
the spa. The ozone output is on whenever the circulation pump is running.
OPERATING INSTRUCTIONS - HS200
To Next Page
Loading...