HOSE REELS: Hose reels are available
for convenient and quick storage of both
discharge and inlet hoses. Different hose
reels options are available for trailer
mounting, machine mounting, wall
mounting, or as base mount options. To
keep the hose from unreeling, lock the
drum in place and secure the gun or the
end of the hose or it may drag on the road. The low-
pressure hose should be of sufficient quality that it will
not flatten out when reeled up, or water supply to the
machine will be cut off.
If the reel swivel begins to leak, replace or connect the
hose directly to the machine until the leak is repaired.
Hose reel swivels with lubrication are pre-lubricated by
manufacturer. Additional lubrication intervals depend
on application and frequency of use. However, a
minimum for re-lubrication, with standard Moly Lith
grease, at 40 hours is recommended. Do not over
grease. Using a hand held grease gun, dispense one
pump of grease into the grease fitting. Depress the ball
bearing at the end of the grease fitting to allow the
grease and air to escape.
HYDRO TWISTER – Surface Cleaners:
The Hydro Twister® is a flat surface cleaner that
connects to a
pressure washer
and uses a spray
bar rotating at a
high speed within 1”
of the ground. It will
clean concrete
more consistently
than an operator
with a spray wand,
with less fatigue,
and 10-20 times
faster. Simply move
the twister over the surface and watch a clean path
appear behind the unit. The Hydro Twister can be used
with hot water, some models up to 250ºF, for extra
stubborn grease or grime, eliminated the need for soap
pretreatment in most applications. Rated to be used
with a pressure washer up to 4000psi and up to 10gpm.
See your dealer for proper nozzle size configurations to
match your pressure washer.
Recovery surface cleaners are also available through
the Hydro Vacuum® product line.
HOT LINK™ HEAT EXCHANGERS:
The Hot Link™ attaches to your cold water pressure
washer and converts it into a hot water pressure
washer. The cold water pressure washer provides high-
pressure water into the Hot Link™ which heats the
water before delivering it through the spray gun and
wand. The Hot Link™ is flow controlled so when the gun
is pulled, the burner automatically starts and stops
when the gun is released. Simply attach to the Hot
Link™ with the jumper hose, provided, to almost any
cold water pressure washer, and attach the pressure
washers hose, gun, wand and nozzles to the outlet on
the Hot Link™. The Hot Link™ system continuously
heats at a 100°F temperature rise and pressure rating
up to 4350psi. (Spray gun and hose must be rated for
at least 200°F and pressure washer must not exceed
4350psi).
HYDRO VACUUM® WASTEWATER RECOVERY
Hydro Tek manufactures Hydro Vacuum®, a product
line of mobile wastewater
recovery accessories.
Starting with containment
berms to divert wash water
away from storm drains
and toward a vacuum
pickup device. The
vacuum system can be
used to simply pickup and transfer the water to a bulk
tank or choose a system to filter the water for washing
reuse or sanitary sewer disposal.
Vacuum system choices are either fully portable (on
wheels) or truck or trailer mount systems.
Dispose of collected wastewater properly: Permits can
be obtained to dump wastewater into a sanitary sewer
system if properly treated and tested. It is illegal to
allow wash water to run into storm drains.
To Next Page
Loading...
Need help?
General
