Hydropool Serenity 45L - Programming Filter and Purge Cycles

21
HYDROPOOL SERENITY SERIES CONTROL SYSTEMS GECKO IN.YE3
NORTH AMERICA / EUROPE
PROGRAMMING THE FILTER / PURGE CYCLES
The filter cycle menu consists of the following parameter: the start me (FS), the duraon (Fd), and the frequency
(FF).
NOTE: A filter cycle consists of starng all the pumps and blower (if equipped) in high speed for 1 minute (purge
step) then the pump associated with the filter cycle will run in low speed for the remaining duraon of the filter
cycle (clean up step).
SETTING THE FILTER CYCLE
Aer you have programmed the clock, the next parameter is the filter cycle start me. The display will show FSxx,
with “xx” represenng the starng hour of the cycle. Use the arrow keys to adjust the hours. Use the Light Key to
jump to the next parameter, filter duraon (Fd).
The display will show Fdxx, with “xx” represenng the duraon in hours of the filter cycle. Use the arrow keys to
adjust the duraon. Use the Light Key to jump to the next parameter, filter frequency (FF).
The display will show FFxx, with “xx” represenng the number of cycles per day. Use the arrow keys to adjust the
frequency. Use the Light Key to jump to the next parameter, economy mode (EP)
This mode allows you to lower the temperature set point of the spa by 20F (11C) during a certain period of the
day.
The display will show Epx, with “x” represenng the state of the programming (0 = disabled, 1 = enabled). Use the
arrow keys to enable or disable the economy mode. Use the light key to jump to the next parameter, economy
start me (ES).
When the Economy mode in ON, the display will toggle between the “Eco” message, the me and the water
temperature.
The display will show ESxx, with “xx” represenng the hour at which the economy mode will become acve. Use
the arrow keys to adjust the hour. Use the Light Key to jump to the next parameter, economy duraon (Ed).