Hydropool SS19ET - Modifying Water Care Schedules; Spa Filtration System

28
MODIFYING SCHEDULES
To see and / or modify the Water
Care category, use the Sengs icon
to open the selected Water Care menu.
Scroll through the menu to choose a schedule
to modify (choice of economy and filtraon
schedules).
You have several possibilies for the schedule
(Mon-Fri, weekend, every day, or single days).
The schedules will be repeated every week.
The me and duraon are set in 30 minute
increments. Once you have set the schedule,
use Spa Funcon Icon to go back. Ensure that
you have selected the desired Water Care
opon in the main Water Care menu.
The filtraon schedule shown on the screen
will apply to the main filtraon pump. Your
spa uses a circulaon pump configured to run
24 hours by default and the screen will show
you the purge seng instead of filtraon. The
purges are pre-programmed for a fixed
number of minutes, therefore the duraon
will be set to N/A on the screen, and only the
start me can be modified.
FILTERING
Your spa is equipped with a circulaon pump
that filters your water for 24 hours a day. If
the water temperature exceeds the set
temperature by 4°F (and set point is 95°F or
higher) then this pump will shut off
automacally unl the temperature drops
below the set point by approximately 1.5°F.
You can bypass the pack filtraon
over-temperature feature. When Warm
weather is "Off", the filtraon
over-temperature is disabled. This feature
allows the spa to connue filtering even
through the water temperature is high.
MAINTENANCE
From the Sengs page you can access the
Maintenance Menu, which gives you access to
the following opons:
· Maintenance reminders
· Standby
Press the text to make a selecon.