Need help?Do you have a question about the Hydrovane HR04E10-4035S000 and is the answer not in the manual?
Identification of hazard symbols for electric shock, danger, and hot surfaces.
Explanation of various warning symbols for safe operation and potential hazards.
Essential safety instructions for competent persons operating and maintaining the compressor.
Ensuring adequate airflow for cooling by proper positioning of intake and outlet.
Critical safety warnings for electrical connections performed by qualified electricians.
Precautions and steps for safe mains electrical connection and isolator use.
Procedure to check and correct compressor rotation to prevent serious damage.
Pre-start checks including oil level, leaks, valve position, and emergency stop.
Procedure and warnings for starting the compressor in automatic operation mode.
Instructions for starting the compressor in continuous operation mode.
Starting procedure for variable speed (RS) models to match system demand.
Procedure for using the emergency stop button and resetting the unit.
Warning and procedure for pressure adjustments by trained service engineers.
Adjusting load/cut-in and unload/cut-out pressures for RS compressors.
Recommended routine service tasks based on running hours and conditions.
Critical safety warnings before performing maintenance on the compressor.
Checks for overheating and tight connections on electrical components.
Information on warning and fault messages, their meaning, and rectification.
General| Model | HR04E10-4035S000 |
|---|---|
| Category | Air Compressor |
| Power Source | Electric |
| Power | 4 kW |
| Pressure | 10 bar |
| Drive Type | Direct Drive |
| Noise Level | 68 dB(A) |
| Voltage | 400V |
| Type | Rotary Vane |
| Motor Power | 4 kW |
| Maximum Pressure | 145 psi |
| Free Air Delivery (FAD) | 0.35 m³/min |
To Next Page
