HYOSUNG RT125D - Riding Tips; Starting the Engine

32
1. Inspect every day once before riding
the motorcycle.
2. The transmission is in neutral.
3. The fuel cock lever is in the ON
position.
4. The ignition switch is in the “ON”
position.
5. The engine stop switch is in the 
position.

When the engine is cold :
1. Turn the carburetor choke lever all the
way toward you.
2. Close the throttle grip and push the
starter switch.
3. Immediately after the engine starts,
return the choke lever halfway and
warm up the engine.
4. Return the choke lever all the way back
to its disengaged position.

When the engine is warm :
1. Open the throttle grip 1/8 ~ 1/4.
2. Push the starter switch.
RIDING TIPS
STARTING THE ENGINE
Before attempting to
start the engine make
sure :
Operation of the carburetor choke
system is not necessary when the
engine is warm.
CAUTION
10. Install the engine oil filler cap.
11. Operate the engine a few seconds by
idling speed.
Inspect to leak oil at the oil filter cap.
12. Confirm the oil level with the oil level
lens after waiting about a minute next to
stopping the engine.
The oil level is located between the
Lower line mark (L)and the Upper
line mark (F).
When below the Lower line mark (L),
refill the oil between the Lower line
mark (L)and the Upper line mark
(F).
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour engine oil
excessively.
CAUTION