Hypercom T7 series - Page 39

Chapter 1
1-22 T7 Series Troubleshooting Manual 940114-020
– 0A = T7P Thermal
– 0B = T77T
3. Select the appropriate Printer setting and press Enter.
4. Press Cancel to exit the Boot level menu.
5. Press the key sequence: Function 3, Enter to exit the terminal’s Boot level and return to the
Idle prompt.
8VSYFPIWLSSXMRKXLI4VMRXIVW
4)4VMRXIVW
Step-by-Step
To clear a paper jam:
1. Disconnect the power cable from the back of the printer.
2. Disconnect the printer cable from the back of the printer.
3. Remove the paper from the printer.
4. Lift the printer lid.
5. Pull the silver metal tab towards the front of the printer. The metal cover should pop off.
6. Examine the interior of the paper guide and clear out any jams.
7. Reconnect the printer cable to the back of the terminal.
8. Reconnect the power cable and run a printer test by pressing the key sequence: Function 8,
2, Enter.
WARNING
Do not stick any sharp objects inside the printer. This can result in permanent damage to the
printer or the printer guide.