Hypercom T7 series - Program Loading a Terminal with Software

Chapter 1
1-14 T7 Series Troubleshooting Manual 940114-020
4VSKVEQ0SEHMRKE8IVQMREP[MXL7SJX[EVI
The terminal dials the NMS telephone number in the Function 2 parameters and initiates a
program load for the software application shell. This process takes approximately five minutes
per page or a total of 25 minutes.
N
OTE: After you complete this procedure, you will need to initialize the terminal to download the
merchant’s specific profile.
One of the following screens appear, depending on the terminal’s EPROM version.
7GVIIR 
7GVIIR 
Step-by-Step
To program load a terminal for a software application:
If the terminal has an EPROM version of 2.00 or
higher, the following message appears.
NOTE: PE means Program Error, indicating the
terminal has no software.
3/($6(,1,7,$/,=(
25&$//+(/33(
9 The terminal has been configured with new
parameters and will need a program load to
receive the new software application. Refer to
“Program Loading a Terminal with Software” on
page 1-14.
Step Action Terminal display
EPROM version Terminal display
If the EPROM is less than 2.00, the terminal
displays the following message.
&21),*85(7(50,1$/
25&$//+(/33(
EPROM version Terminal display
If the EPROM is 2.00 or higher, the terminal
displays the following message.
3/($6(,1,7,$/,=(
25&$//+(/33(
Step Action Terminal display
1 Press the key sequence: Function, 9, 2, Enter. 0(5&+$17)81&7,21
