• Programming is complete when the unit reaches 100%.
(Programming takes approximately 5 minutes)
The following screens will appear:
• Turn the ignition key to OFF for at least thirty (30) seconds.
Press the ‘Y’ button and remove the programmer cable from
the DLC under the dash panel.
• Start the engine and make sure the Service Engine Soon light
on your instrument cluster goes out (If it stays on or flashes,
call Hypertech at 901-382-8888). Warm the engine up and
make sure it is running smoothly.
• CHECK FOR DETONATION. Whether you have selected
Power Tuning for premium (the highest octane rating available
in your area) or regular octane gasoline, you need to check for
detonation. This is a “pinging” sound heard during heavy
throttle acceleration, indicating the presence of detonation.
Make certain you are using gasoline intended for the Power
Tuning you have installed. If any “pinging” sound is heard,
you should immediately back off the throttle. To discuss,
call Hypertech at 901-385-1888
.
17
TURN KEY OFF
FOR 30 SECONDS
HYPERTECH POWER
TUNING INSTALLED
TO END, PRESS Y
AND UNPLUG CABLE
To Next Page
Loading...
