J. PROGRAMMING
IMPORTANT NOTE: On certain applications, the dash
message center may display random code information such
as REDUCED ENGINE POWER. This is a NORMAL step
during the programming process for certain applications.
•
First, the programmer will read out your vehicle’s stock program.
• When the programmer has finished this, it will wait a few
seconds and then begin programming the changes into your vehicle.
• This display will show percentage completion while the
programming is taking place. While the unit is programming,
the following is EXTREMELY IMPORTANT:
* DO NOT LEAVE THE VEHICLE WHILE
PROGRAMMING IS IN PROCESS.
* DO NOT DISTURB THE CABLE.
* DO NOT TURN THE KEY OFF.
* DO NOT START THE ENGINE.
* IF THE UNIT STOPS PROGRAMMING OR IS
INTERRUPTED, PLEASE MAKE A NOTE OF ANY
MESSAGE(S) THAT APPEAR ON THE PROGRAMMER
SCREEN. THIS WILL BE HELPFUL TO OUR
TECHNICAL DEPARTMENT.
• Any one of these actions will disturb the programming process.
The programmer is designed to recover from these conditions,
but they should be avoided.
16
READING COMPUTER
XX%
WRITING COMPUTER
XX%
IMPORTANT NOTE: If during the reading and/or programming stage, the
Power Programmer does not show an increase in percentage for at least five
(5) minutes, LEAVE THE KEY IN THE ‘ON’ POSITION and unplug the
Power Programmer
from the diagnostic port. Then, reinsert the cable
into
the diagnostic port and press the s button. This will allow the programming
to continue. If the problem continues, call Hypertech at 901-382-8888.
To Next Page
Loading...
