26
Problem
May Be Caused By What To Do
The electrical oven does
not heat to the selected
temperature set on the
knob.
●
Incorrect electrical wiring
installation.
●
Check that your oven door
is completely closed.
●
Oven is being used in an
environment below room
temperature.
●
Contact the electrician that
installed the oven and ask
them to check the wiring,
please reference the wiring
diagram.
●
Attempt the baking cycle
again and see if it does the
same thing.
●
Ensure you have given the
oven an adequate amount of
time to reach the temperature
selected. Example: 10-15
minutes to reach 350
degrees Fahrenheit.
●
Ensure the oven is indoors
and not outdoors at room
temperature or higher.
The burner flame turns off
after I release the knob to
the burner.
●
Low gas pressure
●
Loose thermocouple or
solenoid magnet
●
Check the gas pressure
coming into the range.
●
Check for loose wiring.
●
Check for a loose solenoid
magnet located inside each
gas valve.
Loud noise in the back of
the oven
●
Convection fan motor
may be obstructed or
blocked.
●
Incorrect electrical wiring
installation.
●
Damage to appliance
due to mishandling.
●
Improperly installed
rotisserie kit.
●
Check the convection fan
motor located in the back
interior wall of the oven.
Ensure it is not loose and is
able to turn with ease. You
may need to disassemble
the back wall to check this.
●
Check rotisserie
connection.
●
Contact the electrician that
installed the oven and ask
them to check the wiring,
please reference the wiring
diagram.
HTDF366 – Affluent Series Range Troubleshooting
www.hypotheory.com
To Next Page
Loading...