4 | www.hysecurity.com SMART DC BOARD INSTALLATION INSTRUCTIONS D0360 REV. I ©2018
SETTING THE OPERATOR TYPE
After replacing an SDC board and supplying
power, the display prompts you to address the
operator type. Depending on what operator
type you have, several other prompts need to
be addressed before the operator will enter Run
Mode.
1. Press SELECT. Display characters blink which
indicates that the menu item can be addressed.
2. Use the NEXT and PREV buttons to scroll
through the options and display the appropriate
data for entry before pressing Select again to
lock-in the selection.
NOTICE
Make sure you designate the correct operator
type! Refer to Table 3.
3. The display prompts you to complete the
standard setup. A sequence of menus, such
as build year, usage class, gate handing, or
model number need to be addressed before
the operator will work properly. Pressing
NEXT allows you to ow through the set up.
If necessary, review the operator’s product
manual.
4. When the last menu item in the series is
addressed, the operator enters Run Mode and
a gate status appears on the display.
Load operator’s custom settings that you saved
in the S.T.A.R.T. backup copy or wrote on the
worksheet on "Smart DC Controller Worksheet"
on page 2. This reprograms the replacement
SDC board with the same settings and operator
functionality as the old board.
NOTICE
If you make a mistake and need to redene the
operator type, use a PC and S.T.A.R.T. software
version 3.00 or higher to reset the operator
type. If necessary, contact HySecurity Technical
Support at 800-321-9947.
To Next Page
Loading...
Need help?
General