D0360 REV. I ©2018 SMART DC INSTALLATION INSTRUCTIONS www.hysecurity.com | 7
Table 5. HySecurity Gate Operators requiring External Monitored Entrapment Protection Sensors
HySecurity Gate Operator
(includes Modular, Correctional, and UPS
models)
Build Year
post-2016
(set at the
factory)
UL 325 Entrapment Protection Device Monitoring Required
Normally Closed (NC) sensors tested & approved.*
Three SENSOR Inputs On Controller.
Installer Menu congurable.*
Build Year (BY) factory-set to post-2018.
SlideDriver 15, 40, 30F, 80, 200 2 or 3
•
SlideDriver 50VF series 2 or 3
•
SlideSmart DC 15 & DCS 15 2 or 3
•
SlideSmart DC 10F & DCS 10F 2 or 3
•
SlideSmartDC HD 25 & HD 30 2 or 3
•
SwingRiser 14, 14-Twin, 19, 19-Twin, 30,
30-Twin
2 or 3
•
SwingSmart DC 20 & DCS 20 2 or 3
•
HydraSwing 2 or 3
•
HydraLift 10, 10F, 20, 20F 2 or 3
•
Table 6 indicates those HySecurity gate operators that may be within the exception parameters of UL
325 or comply with standards other than UL 325, but continue to maintain object detection capabilities.
HySecurity strongly recommends that you assess every site for entrapment zones and provide the
necessary protection to guard against entrapment.
Table 6. HySecurity Gate Operators maintaining Object Detection
HySecurity Gate Operator with
Obstruction Protection (Object
Detection)
Build Year
2018
Sensor Inputs automatically set to "NOT USED"
Installer has option to change settings as site design dictates.
StrongArm (HTG) 2 or 3
•
StrongArmCRASH (M30/M50) 2 or 3
•
StrongArmPark DC 10 & DCS 10
StrongArmPark DC 14 & DCS 14
2 or 3
•
WedgeSmart DC 10 & 10 DCS
WedgeSmart DC 14 & 14 DCS
2 or 3
•
HydraWedge SM50 2 or 3
•
NOTE: For more information, refer to the Quick Start Supplement describing changes to HySecurity software due to UL
325 - 2016 Standard of Safety updates. Review the information regarding monitoring of external entrapment protection
sensors online at www.hysecurity.com/gatesafety
To Next Page
Loading...
Need help?
General