To Next PageTo Next Page
Need help?Do you have a question about the Hyster J1.5-2.0XNT and is the answer not in the manual?
General| Model | Hyster J1.5-2.0XNT |
|---|---|
| Category | Forklifts |
| Power Source | Electric |
| Lift Height | up to 6500 mm |
| Travel Speed | up to 16 km/h |
| Voltage | 48V |
| Number of wheels | 4 |
| Load Capacity | 1.5-2.0 tons |
| Battery Capacity | 48V |
| Overall Width | 1200 mm |
| Tire Type | Pneumatic |
Outlines the hierarchy of main menus and their presentation on the display.
Explains how to view and change the truck's performance mode settings.
Describes icons used to display truck status and active warnings.
Details the Battery Discharge Indicator (BDI) and its relation to battery state of charge.
Details the process for setting up initial Supervisor and other passwords.
Explains how to manage passwords via the Truck Setup menu.
Guides through the process of calibrating the load weight measurement system.
Explains calibration for returning the mast to a set tilt stop point.
Details calibration for E-Hydraulic and manual valve thresholds.
Describes calibrating the steering wheel knob for straight-ahead driving.
Explains calibration for the steer axle position, used with specific steering systems.
Allows Service Technicians and Supervisors to add or remove passwords.
Configures regenerative braking rate, auto deceleration rate, and type.
Adjusts truck voltage, ampere, and cell voltage settings.
Adjusts the Parasitic Current setting for Battery Discharge Indicator accuracy.
Sets acceleration limits at low and high speeds, and performance mode.
Adjusts system reaction settings after an impact is detected.
Configures reminders for scheduled maintenance based on time or hours.
Sets the maximum traction speed limit in MPH or km/h.
Adjusts settings for impact detection, force, and time.
Explains how to access and view fault codes for various truck components.
