To Next Page

To Previous Page

●

United States Federal Communications Commission, Code of Federal Regulations; 47CFR part 2 sub-part J;

●

American National Standards Institute (ANSI)/Institute of Electrical and Electronic Engineers (IEEE) C95. 1-1992;

●

Institute of Electrical and Electronic Engineers (IEEE) C95.1-1999;

●

International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998.

FCC Regulations

Federal Communication Commission (FCC) requires that all radio communication products should meet the requirements set forth in the above standards

before they can be marketed in the U.S, and the manufacturer shall post a RF label on the product to inform users of operational instructions, so as to

enhance their occupational health against exposure to RF energy.

Operational Instructions and Training Guidelines

To ensure optimal performance and compliance with the occupational/controlled environment RF energy exposure limits in the above standards and

guidelines, users should transmit not more than 50% of the time and always adhere to the following procedures:

●

RF energy will be generated only when the radio is transmitting.

●

The radio must be 2.5 centimeters away from human body when transmitting.

EU Regulatory Conformance

As certied by the qualied laboratory, the product is in compliance with the essential requirements and other relevant provisions of the Directive 1999/5/

EC.

Please note that the above information is applicable to EU countries only.