Hytera PD706 User Manual

13
Appendix
Signaling Introduction
The radio supports the following signaling. You can ask
your dealer to make appropriate settings on the radio.
For detailed information, please consult your dealer.
HDC1200
The HDC1200 signaling is compatible with the
MDC1200 signaling, and realizes functions such as PTT
ID (Encoding & Decoding), Emergency (Encoding &
Decoding) and Selective Call (Encoding & Decoding).
Encoding
When initiating a normal call, hold the PTT key during
normal voice communication to send PTT ID. For
encoding, the radio will provide the following indications:
● PTT ID/Selective Call: Your dealer can program
whether the radio sounds side tone during encoding
or beeps after encoding.
● Selective Call: During encoding, the LED glows red.
After encoding, the LED glows orange.
Decoding
For decoding, the radio provides the following
indications:
● Selective Call: After decoding, the radio provides the
following indications:
»
Tone: The radio will give the tone by default.
»
LED: The LED glows green.
5-Tone
The radio can realize various types of calls through
5-Tone signaling.
Encoding
1. Request your dealer to congure the correct format
and type for the encoding contents.
2. When the format consists of xed codes only, you do
not have to edit such elds or save such data.
3. Hold the PTT key or press the programmed One
Touch Call key to send the 2-Tone signaling.
During encoding, the LED glows red and the Side
tone will be given. If Auto Reset is enabled (by your
dealer), the radio will enter the Auto Reset mode after
successful encoding, with the LED glowing orange,
until the Auto Reset Time expires.
Decoding
The radio can automatically decode the 5-Tone signaling
when receiving any matched one.
During decoding, the LED glows green. If Auto Reset is
enabled (by your dealer), the radio will enter the Auto
Reset mode, with the LED glowing orange, until the Auto
Reset Time expires.
2-Tone
With the 2-Tone signaling, the radio can transmit and
receive 2-Tone calls.
Encoding
1. Request your dealer to congure the correct format
and type for the encoding contents.
2. Hold the PTT key or press the programmed One
Touch Call key to send the 2-Tone signaling.
During encoding, the LED glows red and the Side
tone will be given. If Auto Reset is enabled (by your
dealer), the radio will enter the Auto Reset mode after
successful encoding, with the LED glowing orange,
until the Auto Reset Time expires.
Decoding
The radio can automatically decode the 2-Tone signaling
when receiving any matched one.
During decoding, the LED glows green. If Auto Reset is
enabled (by your dealer), the radio will enter the Auto
Reset mode, with the LED glowing orange, until the Auto
Reset Time expires. The radio cannot enter the Auto
Reset mode if the call is an alert call.

Hytera PD706 Specifications

General

Brand	Hytera
Model	PD706
Category	Portable Radio
Language	English