Hytera PD706 User Manual

11
Troubleshooting
Phenomena Analysis Solution
Power-on failure
The battery may be improperly installed. Remove the battery and attach it again.
The battery may run out. Recharge or replace the battery.
The battery may suffer from poor contact caused
by dirtied or damaged battery contacts.
Clean the battery contacts. If the problem can not be solved, contact your dealer
or authorized service center for inspection and repair.
During receiving, the voice is weak,
discontinuous or totally inactive.
The battery power may be too low. Recharge or replace the battery.
The volume may be set to a low level. Increase the volume.
The antenna may get loose or improperly installed. Power off the radio, and re-install the antenna.
The speaker may be blocked or damaged.
Clean surface of the speaker. If the problem can not be solved, contact your
dealer or authorized service center for inspection and repair.
You can not communicate with other
members.
The frequency or signaling may be inconsistent
with that of other members.
Set your TX/RX frequency and signaling to the same as that of other members.
The channel type (digital/analog) may be set
inconsistently.
Make sure all members are on the same digital/analog channel.
You may be too far away from the group members. Move towards other members.
Irrelevant communication or noise is
heard on the channel.
You may be interrupted by radios using the same
frequency.
Change the frequency, or adjust the squelch level.
The radio may be set with no signaling. Set signaling for all member radios to avoid interference at the same frequency.
The noise is too loud.
You may be too far away from other members. Move towards other members.
You may be at an unfavorable position. For
example, your communication may be blocked
by high buildings or frustrated in the underground
areas.
Move to an open and at area, and restart the radio to try again.
You may suffer from external disturbance (such as
electromagnetic interference).
Stay away from equipment that may cause interference.
The GPS cannot locate your position.
▼
No GPS signal is received. Move to an open and at area, and restart the radio.
If the above solutions can not x the problems for you, or you may have some other queries, please contact us or your local dealer for more technical support.

Hytera PD706 Specifications

General

Brand	Hytera
Model	PD706
Category	Portable Radio
Language	English