Hytera RD62 series - Page 11

6
3.2.2 Installation Procedures
Step 1 Install the wall-mount bracket.
1. Drill three holes into the wall, with each hole aligned with those of the wall-mount bracket.
2. Put the plastic wall anchor into the drilled holes. Skip this step if the wall is not a concrete wall.
3. Use three ST4X16 self-tapping screws to fasten the bracket on the wall.
Note: Make sure the wall can support the repeater’s weight before drilling.
Step 2 Install the repeater on the bracket.
1. Align the screws on the upper side of the repeater with the notches of the bracket and mount
the repeater onto the bracket, as shown in the figure below;
2. Move the repeater side to side slightly to ensure the screws fit into the bottom of the notch.