4
1 Baseband Module 4 Exciter Module
2 Front Panel 5 Receiver Module
3 PA Module
Installation Guide
Proper installation can ensure optimum performance and reliability of the repeater. Therefore, be sure to
read the following instructions before installation.
Installation Requirements
Installation Environment
The repeater must be installed in a dry and well-ventilated place with ambient temperature of
-30℃~+60℃ and relative humidity of less than 95%.
Installation Location
The repeater can be installed in a rack, bracket, cabinet or on a desk.
Installation Tools
Tools required for installing the repeater include a cross head screwdriver, a torx screwdriver and a
spanner.
Note: Please refer to Safety Information Booklet for more information.
Before Installation
1. Voltage Check
Please check whether the voltage of DC power or battery meets the repeater specifications.
2. Product Check
Please check whether the repeater works properly by observing the 8 LEDs located in the front panel.
3. Parameter Configuration
When the repeater proves to work normally, configure appropriate parameters according to your actual
requirements. And then you can proceed with on-site installation.
To Next Page
Loading...
