Hytera RD988 U5 - FCC Regulations; Compliance with RF Exposure Standards; Operational Instructions and Training Guidelines

C95. 1-1992;
 Institute of Electrical and Electronic Engineers (IEEE) C95. 1 – 1999;
 International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998;
FCC Regulations
Federal Communication Commission (FCC) requires that all radio communication products
should meet the requirements set forth in the above standards before they can be marketed
in the U.S, and the manufacturer shall post a RF label on the product to inform users of
operational instructions, so as to enhance their occupational health against exposure to RF
energy.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Compliance with RF Exposure Standards
To control your exposure and ensure compliance with the occupational/controlled
environment exposure limits, this equipment should be operated with minimum distance
350cm between the radiator& your body.
Pour contrôler votre exposition et assurer le respect des valeurs limites d'exposition
professionnelles environnement / contrôlée, cet équipement doit être utilisé avec une
distance minimale de 350 cm entre le radiateur et votre corps.
Operational Instructions and Training Guidelines
To ensure optimal performance and compliance with the occupational/controlled
environment RF energy exposure limits in the above standards and guidelines, users should
always adhere to the followings:
Gain of antenna must not exceed 6.5dBi.
Antenna Installation: install the antenna at least 3.5 meters away from your body,
in accordance with the requirements of the antenna manufacturer/supplier.
EU Regulatory Conformance
As certified by the qualified laboratory, the product is in compliance with the essential requirements and
other relevant provisions of the Directive 1999/5/EC. Please note that the above information is applicable
to EU countries only.