Hytera RD988 - After-installation Verification; Status Indication

4
Installation Diagram
Duplexer with Front Side Facing Upwards
Duplexer with Front Side Facing Downwards
After-installation Verication
After installation is completed, power it on and verify
whether it works properly by observing the 8 LEDs
located in the front panel.
Status Indication
LCD Icon
These icons may appear on the LCD to help you easily
identify the repeater status.
Icon Name Icon Repeater Status
RSSI Indicator
*
More bars indicate
better signal
strength.
TX Power
Indicator
Low TX power for
the current channel.
High TX power for
the current channel.
Scan Indicator Scan is in progress.
Monitor
Indicator *
The Monitor feature
is active.
Speaker
Indicator
The speaker is
unmuted.
Alarm Indicator
An alarm message
is given.
Icon Name Icon Repeater Status
Accessory
Indicator *
An accessory is
connected.
Scrambler/
Encrypt
Indicator
The Scrambler/
Encrypt feature is
active.
Operation
Mode Indicator
RM
The repeater is
operating in Repeat
mode.
LED Indicator
LED Indication
Part
No.
Repeater Status
Power Indicator glows
green.
2 Normal power-on
Alarm Indicator glows
red.
10 Abnormal operation
Repeat Mode Indicator
glows green.
3
The repeater is
operating in Repeat
mode.
Repeat Mode Indicator
goes out.
3
The repeater is
operating in Base
mode.
Slot 1 TX Indicator glows
red.
8
The repeater is
transmitting on an
analog channel or on
slot 1.
Slot 1 RX Indicator glows
green.
9
The repeater is
receiving on an
analog channel or on
slot 1.
Slot 2 TX Indicator glows
red.
6
The repeater is
transmitting on slot 2.
Slot 2 RX Indicator glows
green.
5
The repeater is
receiving on slot 2.
Analog Mode Indicator
glows yellow.
4
The repeater is
operating in Analog
mode.
Digital Mode Indicator
glows blue.
7
The repeater is
operating in Digital
mode.
Screw
RF Cable
Screw
Screw RF Cable
Screw